Ogden & Weber County Radon FAQ

These frequently asked questions draw directly on published guidance from the U.S. Environmental Protection Agency (EPA), the Utah Department of Environmental Quality (DEQ), the Utah Geological Survey (UGS), the Weber-Morgan Health Department, the Bear River Health Department, and pre-mitigation laboratory summaries compiled by UtahRadon.org. This page provides general homeowner education, not medical, engineering, or legal advice.

What is radon and why does it enter Ogden homes?

Radon is a colorless, odorless, tasteless radioactive gas formed by the natural decay of uranium present in rock and soil. Because indoor spaces—especially heated Utah basements during fall and winter—typically sit at slightly lower air pressure than the surrounding ground, homes act like gentle vacuums that draw soil gas up through foundation cracks, floor-to-wall joints, control joints, hollow concrete block walls, sump pits, and exposed crawl-space dirt. According to the EPA, radon is the number one cause of lung cancer among non-smokers and the second leading cause of lung cancer overall, linked to an estimated 21,000 U.S. lung cancer deaths each year.

What radon level requires mitigation under EPA guidelines?

The EPA recommends mitigating any home with a confirmed radon level of 4.0 pCi/L or higher. Because there is no known safe threshold of radon exposure, the EPA also advises homeowners to consider mitigation when indoor readings fall between 2.0 and 4.0 pCi/L. For context, the EPA reports an average U.S. indoor radon level of about 1.3 pCi/L and an average outdoor air level of roughly 0.4 pCi/L. The World Health Organization uses a 2.7 pCi/L reference threshold.

How high are radon levels in Ogden and Weber County?

Utah DEQ estimates that roughly 1 in 3 Utah homes have elevated radon levels above 4.0 pCi/L. Pre-mitigation test data from Alpha Energy Laboratories (2015 through August 2025, published by UtahRadon.org) puts Weber County's overall average at 4.9 pCi/L across 6,237 residential tests—above both the Utah statewide average of 4.4 pCi/L and the 4.0 pCi/L EPA action level. City averages vary sharply across short distances: Ogden averages 3.9 pCi/L (2,797 tests), North Ogden 7.4 pCi/L (566 tests), Pleasant View 5.6 pCi/L (257 tests), Uintah 4.8 pCi/L (24 tests), Eden 10.3 pCi/L (272 tests), Huntsville 10.9 pCi/L (167 tests), Liberty 17.4 pCi/L (51 tests), and Farr West 21.5 pCi/L (171 tests), while Roy (1.9 pCi/L), West Haven (1.9 pCi/L), and Hooper (1.6 pCi/L) average lower. Just north of Weber County, Brigham City averages 7.1 pCi/L (611 tests) within Box Elder County's 7.5 pCi/L average.

Why do radon levels vary so much between East Bench, Ogden Valley, and western Weber County?

Utah Geological Survey reports—specifically Special Study 90, Public Information Series 45 (Lower Weber River Area), and Public Information Series 36 (Ogden Valley)—show that three geologic factors drive hazard potential: soil uranium content, soil permeability, and depth to shallow groundwater. Along the Wasatch mountain front and across the coarse-grained Lake Bonneville Weber delta, permeable sediments derived from uranium-bearing bedrock such as the Precambrian Farmington Canyon Complex allow radon gas to migrate upward freely. In Ogden Valley, UGS identified soils west of Liberty derived from metamorphic rock along the northwest valley margin as carrying the highest geologic radon potential. Toward the Great Salt Lake shoreline, finer lakebed clays and shallow water tables reduce average geologic potential—yet Farr West's 21.5 pCi/L test average demonstrates why UGS warns that maps never substitute for testing your own building.

How can Weber County and Brigham City homeowners test for radon?

You have several low-cost and free options before hiring a contractor. Weber and Morgan County residents can borrow a digital radon monitor for 7 days at no charge through the Weber-Morgan Health Department (477 23rd Street, Ogden; call or text 801-399-7265 to reserve). Brigham City and Box Elder County residents can pick up a $9.00 radon test kit from the Bear River Health Department office at 817 Parker Lane in Brigham City. Any Utah resident can also order a low-cost mail-in short-term kit through the Utah DEQ Radon Program, buy a retail kit at a hardware store, or request a certified radon measurement professional—especially when testing under a real estate deadline.

What are the rules for running an accurate short-term radon test?

Utah DEQ's instructions specify placing the test kit in the lowest regularly lived-in level of the home (a used basement, den, office, or first floor), at least 20 inches above the floor, 3 feet from exterior walls, and 1 foot from interior walls, away from drafts, direct heat, high humidity, kitchens, and bathrooms. Close windows and exterior doors at least 12 hours before starting the test and keep them closed as much as possible during the 48 to 72 hour exposure window. Kits exposed for fewer than 2 days or more than 7 days become invalid.

What should I do if my first radon test comes back at 4.0 pCi/L or higher?

Follow Utah DEQ and EPA confirmation steps: if a short-term test reads 4.0 pCi/L or higher, take a follow-up test—either a long-term test (more than 90 days, best for measuring your year-round average) or a second short-term test. If the initial short-term reading is more than twice the 4.0 pCi/L action level (above 8.0 pCi/L), take a second short-term test right away so you do not delay mitigation. Fix the home if a long-term test confirms 4.0 pCi/L or higher, or consider fixing if the average of two short-term tests is 4.0 pCi/L or higher. If your level tests below 4.0 pCi/L, Utah DEQ recommends retesting every two to five years.

How does a typical radon mitigation system work in Utah homes?

The most common and reliable method is active sub-slab depressurization (active sub-slab suction). As Utah DEQ describes it, a certified mitigator drills a five-inch suction hole through the basement or ground-floor concrete slab, routes four-inch PVC piping to a continuous-duty exhaust fan mounted outdoors or inside an unconditioned attic space, and discharges radon gas above the roofline—at least 10 feet above ground and clear of windows and doors per EPA installation standards. The fan establishes a stronger vacuum beneath the slab than the house creates, intercepting radon before it enters living areas. EPA data shows active sub-slab and crawl-space sub-membrane systems typically reduce indoor radon by 50% to 99%, and Utah DEQ notes most homes can be brought to 2.0 pCi/L or lower.

How much does radon mitigation cost in Ogden and northern Utah?

Published Utah public-source benchmarks give a realistic planning range, though only an on-site contractor quote sets your final price. Utah DEQ states that an active mitigation system in an existing home typically costs around $2,000. UtahRadon.org cites a statewide installation range of $800 to $2,500 for most residential systems. Homes with multi-level foundations, finished basements requiring creative pipe routing, combination slab-and-crawl-space footprints, or older hollow block walls can land toward the higher end. Utah DEQ advises getting at least three written bids and asking for a target post-mitigation radon level in your signed contract.

What are the ongoing operating and maintenance costs of a radon system?

Because the exhaust fan must run continuously to maintain sub-slab vacuum, Utah DEQ estimates ongoing electricity costs of roughly $8 to $10 per month on your utility bill. Utah DEQ notes the fan itself generally needs replacement after about 15 years, while the EPA notes fans may last five years or longer and manufacturer warranties typically do not exceed five years. Check your system's warning device (usually a liquid U-tube manometer on the riser pipe) periodically to verify vacuum draw, and run a follow-up radon test within 30 days of installation (at least 24 hours after startup) and every two years thereafter.

Does Utah law require radon testing or mitigation when selling a house?

We are not aware of any federal or Utah statute that legally mandates a radon test or mitigation system as a condition of selling a home. However, the EPA recommends testing whenever a home is bought or sold, and Utah DEQ's real estate guidance highlights the standard seller's property disclosure question regarding known radon test results or mitigation systems. Buyers routinely negotiate testing during the inspection window. For binding legal or contractual guidance on a specific transaction, consult your Utah real estate agent or a real estate attorney.

Do newly built homes in West Haven, Farr West, or North Ogden need radon testing?

Yes. The Utah Geological Survey notes that while Utah adopted the 2015 International Residential Code (IRC) statewide, Appendix F (Radon Control Methods) was omitted, meaning builders are not legally required to include radon-resistant new construction (RRNC) features. Even when a builder voluntarily installs a gravel layer, vapor barrier, sealed slab joints, and a passive PVC vent stack, the EPA emphasizes that every new home must be tested after occupancy. Passive stacks typically cut radon by 30% to 70%; if post-occupancy testing still reads 4.0 pCi/L or higher, a certified mitigator can activate the stack by adding an inline radon fan.

What license and certification must a Utah radon contractor hold?

Utah DEQ states that any contractor installing a radon mitigation system must hold both national radon mitigation certification (through NRPP or NRSB) and an active Utah state contractor's license from DOPL under an eligible class (B100, R100, E200, P200, S350, or S354 Radon Mitigation Contractor). Handyman registration does not authorize installing a mitigation system, and contracting without a license in Utah is a Class A Misdemeanor. Always verify both credentials yourself before signing.

Does Radon Mitigation Ogden charge homeowners or install systems?

No on both counts. Radon Mitigation Ogden is an independent referral service. You pay nothing to submit an estimate request, and the independent local professional we connect you with provides a free estimate. We may receive a referral fee from independent contractors. You stay in complete control of which contractor you hire, and all contracts, permits, and warranties are solely with that contractor.

Get a Free Estimate

Get a Free Estimate